Extractor de rodamientos y poleas 300mm 3 garras TSX TOOL

Aquest extractor de rodaments i politges està fabricat principalment en acer amb tractament tèrmic, cosa que li confereix alta resistència mecànica i bona durabilitat sota ús repetit. L’acer tractat redueix el risc de deformació o desgast prematur a les grapes i a l’eix de pressió.

L’extractor permet un rang d’obertura efectiva de fins a 300 mm, adequat per a peces com politges i rodaments d’aquest diàmetre màxim. La seva capacitat de càrrega depèn del material extret, però habitualment es recomana no superar càrregues d’extracció de 2 a 4 tones. No està dissenyat per a peces per sobre d’aquestes dimensions o càrregues.

S’aconsella netejar i lubricar periòdicament l’eix de pressió i les zones de contacte de les grapes. Després de cada ús, reviseu que no hi hagi deformacions visibles, oxidació o desgast inusual. L’emmagatzematge ha de ser en un ambient sec per evitar corrosió.

Generalment, l’extractor es lliura com a peça única sense recanvis inclosos. La disponibilitat de peces de recanvi (grapes, cargol central) depèn del fabricant/distribuïdor i pot variar. Es recomana consultar amb el proveïdor per a opcions de postvenda específiques.

This bearing and pulley extractor is mainly made of heat-treated steel, which gives it high mechanical strength and good durability under repeated use. The treated steel reduces the risk of deformation or premature wear on the jaws and pressure screw.

The extractor offers an effective opening range of up to 300 mm, suitable for parts such as pulleys and bearings of that maximum diameter. Its load capacity depends on the material being removed, but it is generally recommended not to exceed extraction loads of 2 to 4 tonnes. It is not designed for parts above those dimensions or loads.

It is advisable to clean and lubricate the pressure screw and the jaw contact areas regularly. After each use, check for visible deformation, rust or unusual wear. It should be stored in a dry environment to prevent corrosion.

Generally, the extractor is supplied as a single unit with no spare parts included. The availability of replacement parts (jaws, central screw) depends on the manufacturer/distributor and may vary. It is recommended to check with the supplier for specific after-sales options.

This bearing and pulley puller is mainly made of heat-treated steel, which gives it high mechanical strength and good durability under repeated use. The treated steel reduces the risk of deformation or premature wear on the jaws and pressure screw.

The puller offers an effective opening range of up to 300 mm, suitable for parts such as pulleys and bearings of that maximum diameter. Its load capacity depends on the material being removed, but it is generally recommended not to exceed extraction loads of 2 to 4 tonnes. It is not designed for parts beyond those dimensions or loads.