Ausbond® Plasticote 80 protector aislante en spray para placas PCB

Ausbond® Plasticote 80 forma una pel·lícula transparent i no conductora que permet soldar directament sobre la protecció, a diferència de molts vernissos que exigeixen retirar-los prèviament. A més, resisteix la humitat, els àcids febles, els raigs UV i temperatures de fins a 120 °C sense degradar-se, oferint més flexibilitat i durabilitat. El seu compliment amb ROHS és un avantatge davant de protectors amb compostos restringits.

El contingut és un polímer acrílic monocomponent en presentació d’esprai. L’envàs estàndard sol contenir 400 ml, tot i que poden existir variants; habitualment fa uns 20 cm d’alçada i 6 cm de diàmetre. El pes total de l’aerosol (incloent-hi l’envàs) és d’aproximadament 450 g. A la caixa s’hi inclou només el pot d’esprai, sense accessoris.

Plasticote 80 és dielèctric, per tant aïlla elèctricament. S’ha d’evitar aplicar-lo sobre connectors, terminals o zones que hagin de mantenir conductivitat. Per obtenir millors resultats, apliqueu capes fines i uniformes, deixant un assecat inicial entre mans. En punts de prova o soldadura, es pot retirar el producte mecànicament si cal.

La capa resultant no requereix un manteniment específic. Si cal reparar la placa, el recobriment es pot retirar amb dissolvents com l’acetona o mitjançant un raspat acurat sense danyar components. Es recomana comprovar la compatibilitat amb plàstics. És important eliminar les restes segons la normativa ambiental vigent.

Ausbond® Plasticote 80 forms a transparent, non-conductive film that allows soldering directly through the protection, unlike many varnishes that require prior removal. It also resists moisture, weak acids, UV rays and temperatures up to 120 °C without degrading, offering greater flexibility and durability. Its ROHS compliance is an advantage over protectors containing restricted compounds.

The contents are a single-component acrylic polymer in spray form. The standard container usually holds 400 ml, although variants may exist; it typically measures around 20 cm high and 6 cm in diameter. The total weight of the aerosol (including the container) is approximately 450 g. The box includes only the spray can, with no accessories.

Plasticote 80 is dielectric, so it electrically insulates. It should not be applied over connectors, terminals or areas that need to remain conductive. For best results, apply thin, even coats, allowing an initial drying time between layers. On test points or solder joints, the product can be removed mechanically if necessary.

The resulting layer requires no specific maintenance. If the board needs repairing, the coating can be removed with solvents such as acetone or by careful scraping without damaging components. Compatibility with plastics should be checked. Any residue should be disposed of in accordance with current environmental regulations.

Ausbond® Plasticote 80 forms a transparent, non-conductive film that allows soldering directly through the protection, unlike many varnishes that must be removed first. It also resists moisture, weak acids, UV rays and temperatures up to 120 °C without degrading, offering greater flexibility and durability. Its ROHS compliance is an advantage over protectors containing restricted compounds.

The contents are a single-component acrylic polymer in spray form. The standard container usually holds 400 ml, although variants may exist; it typically measures around 20 cm high and 6 cm in diameter. The total weight of the aerosol (including the container) is approximately 450 g. The box includes only the spray can, with no accessories.