Alicates crimpadores con terminales 0.25-10 mm² - Kit de 1200 piezas

L'eina està fabricada principalment en acer endurit (alt contingut de carboni) amb tractament superficial antòxid per a la mordassa i el cos. El mànec està recobert amb plàstic ABS ergonòmic i antilliscant. Ofereix bona resistència a l'oxidació en condicions d'ús normal, però no es recomana l'exposició prolongada a ambients humits sense manteniment.

Es recomana netejar l'eina després de l'ús per eliminar restes metàl·liques i pols, aplicar lubricant lleuger a les parts mòbils cada 3-6 mesos i verificar que no hi hagi joc o desgast visible a la mordassa. Ajustar el regulador de trinquet segons el manual per mantenir una pressió de crimpat precisa. No submergir en aigua ni utilitzar dissolvents agressius.

El kit està optimitzat per a terminals tipus puntera de norma europea DIN, però pot funcionar amb terminals equivalents que encaixin en el rang de 0,25-10 mm². Per a terminals calibrats en AWG, consulteu la taula de conversió: 0,25 mm² ≈ 23 AWG i 10 mm² ≈ 8 AWG. La compatibilitat plena només està assegurada amb terminals de mesures i estàndards coincidents.

Els criteris comparatius són: rang de secció admès (0,25-10 mm² en aquest model), disseny del mecanisme de trinquet (ergonomia i seguretat), varietat i quantitat de terminals inclosos (1200 unitats assortides), materials i tractament anticorrosió, facilitat d'ajust i garantia oferta. Aquest model destaca pel seu rang ampli, la inclusió de molts terminals i l'ajust automàtic.

The tool is mainly made from hardened steel (high carbon content) with an anti-rust surface treatment for the jaw and body. The handle is coated with ergonomic, non-slip ABS plastic. It offers good resistance to rust under normal use, but prolonged exposure to damp environments is not recommended without maintenance.

It is recommended to clean the tool after use to remove metal residue and dust, apply light lubricant to moving parts every 3–6 months and check for any play or visible wear on the jaw. Adjust the ratchet regulator according to the manual to maintain precise crimping pressure. Do not immerse in water or use aggressive solvents.

The kit is optimised for European DIN standard ferrule terminals, but it may work with equivalent terminals that fit within the 0.25–10 mm² range. For AWG-rated terminals, consult the conversion table: 0.25 mm² ≈ 23 AWG and 10 mm² ≈ 8 AWG. Full compatibility is only guaranteed with matching sizes and standards.

The comparison criteria are: supported wire cross-section range (0.25–10 mm² in this model), ratchet mechanism design (ergonomics and safety), variety and quantity of included terminals (1,200 assorted pieces), materials and anti-corrosion treatment, ease of adjustment, and warranty offered. This model stands out for its wide range, large number of included terminals and automatic adjustment.

The tool is mainly made from hardened steel (high carbon content) with an anti-rust surface treatment on the jaw and body. The handle is coated with ergonomic, non-slip ABS plastic. It offers good resistance to rust under normal use, but prolonged exposure to damp environments is not recommended without maintenance.

It is recommended to clean the tool after use to remove metal debris and dust, apply light lubricant to moving parts every 3–6 months and check for any play or visible wear on the jaw. Adjust the ratchet regulator according to the manual to maintain accurate crimping pressure. Do not immerse in water or use aggressive solvents.