Cnc Tb6600 Stepper Motor Driver Controller 4a 9v-40v

Cnc Tb6600 Stepper Motor Driver Controller 4a 9v-40v

This TB6600 chip-based driver is a bi-polar stepper motor controller module that allows for various micro-step modes. Compatible with 2 and 4 phase motors from 9V to 40V voltage, the maximum excitation current is less than 4A.

This unit uses current loop subdivision control, motor torque ripple is very small, motor torque curling is very low, and motor speed is very smooth running. The high speed torque is much higher than other two-phase, high-precision positioning units. Widely used in engraving machines, CNC machines, packaging machinery and other equipment. NEMA17, NEMA23, NEMA24 and NEMA34 engines work perfectly with this controller.

It is compatible with Arduino and other microcontrollers that can emit a 5V digital pulse signal. The TB6600 stepper motor controller with 9~40VDC wide-range power supply. It is capable of producing a peak current of 4A, which is sufficient for most stepper motors
Characteristics

Selectable micro-step mode (1/1,1/2,1/4,1/8,1/16 step).
Simple power supply.
Current control (in 8 steps from 0.2 A to 5 A).
Compensation source: 9 ~ 40V DC
Optically isolated inputs
Protection against overvoltage, undervoltage, overcurrent and short-circuit.
High starting speed.
High speed torque.
Heavy-duty black plastic housing and black aluminium heat sink.
Mounting holes on the heat sink for mounting the unit on machine panels.
Technical specifications

DC input voltage: 8 ~ 50V (Operating voltage: 9V - 40V)
Input current from 1 to 5 A
Output current:
IOUT= 5.0 A (Maximum Absolute Nominal Value, peak, 100 ms)
IOUT= 4.5 A (operating range, maximum value)
Operating temperature: -10 to 45
Storage temperature: -40? to 70
Weight: 200 grams
Parts

Microstepper Driver Step Motor Driver - TB6600 - 0.2-5A 12-48VDC - parts

Terminal 1 DC+ In
Terminal 2 DC- In
Terminal 3 Stepper Motor B- Out
Terminal 4 Stepper Motor B+ Out
Terminal 5 Stepper Motor A- Out
Terminal 6 Stepper Motor A+ Out
Terminal 7 Enable Signal DC+ in
Terminal 8 Enable Signal DC- in
Terminal 9 Press (Step) Signal DC+ in
Terminal 10 Press (step) Signal DC- in
Terminal 11 Direction Signal DC+ in
Terminal 12 Direction Signal DC- in
Dip Switch Block for current and resolutionSW1 Current Setting
SW2 Current Setting
SW3 Current Setting
SW4 Resolution Setting
SW5 Resolution Setting
SW6 Resolution Setting