Short descriptio
Pn532 Nfc Rfid Module V3 Kit Reader Writer For Arduino Android BoardPN532 NFC RFID Module V3 Kit Reader Writer for Arduino Android BoardDescription:- This is a popular technology. Almost all the high-end phone in the mar... Read more...
Pn532 Nfc Rfid Module V3 Kit Reader Writer For Arduino Android Board
PN532 NFC RFID Module V3 Kit Reader Writer for Arduino Android Board
Description:
- This is a popular technology. Almost all the high-end phone in the market support NFC.
- It is a kit of standards for smartphones and similar devices to establish radio communication with each other by touching them together or bringing them into close proximity, usually no more than a few centimeters.
- I2C is the data Interface by default.
- With the Arduino Sensor Shield, it is very easy to plug and play.
Features:
- Gilt PCB and Small dimension easy to embed into any project
- It support I2, SPI and HSU (High Speed UART), change between those modes
- Support RFID reading and writing, P2P communication with peers ,NFC with Android phone
- Typical Operating Distance have been updated to 5cm~7cm reading distance
- Work in NFC Mode or RFID reader/writer Mode
RFID reader/writer supports:
- 1k, 4k, Ultralight, and DesFire cards
- ISO/IEC 14443-4 cards such as CD97BX, CD light, Desfire, P5CN072 (SMX)
- Innovision Jewel cards such as IRT5001 card
- FeliCa cards such as RCS_860 and RCS_854
- Plug and play, Arduino compatible
- Built in PCB Antenna, with 4cm~6cm communication distance
- On-board level shifter, Standard 5V TTL for I2C and UART, 3.3V TTL SPI
- Work as RFID reader/writer
- Work as 1443-A card or a virtual card
- Exchange data with other NFC devices such as smartphone
Interface:
The version 3 can support I2C、SPI and HSU (High Speed UART), there is a switch can help you to change interface between those modes easily.
Hardware Connection:
If you have Sensor Shield, you could plug in and play.
And you can finish connection with Arduino by hand :
- Arduino GND to PN532 Module GND
- Arduino 5V to PN532 Module VCC
- Arduino SDA to PN532 Module SDA
- Arduino SCL to PN532 Module SCL
Application:
3 basic examples of this module:
- Read/write RFID card (As basic function, this module could read and write RFID card. Various cards could be supported. Also supply libraries for Arduino.)
- P2P communication (Two PN532 modules could communicate with each other wirelessly.)
- NFC with Andriod Phone (The basic communication stamp with Andriod Phone (NFC supported) is finished. Currently we could put an URL to Android phone and let it visit a webpage.)
Include:
1 x PN532 NFC RFID Module
1 x 2.54 mm spacing 4pin Cable
1 x S50 White Card
1 x S50 Key Card
1 x 12P bended male pins
Tags: pn532, nfc, rfid, module, v3, kit, reader, writer, arduino, android, board-pn532, nfc, rfid, module, kit, reader, writer, arduino, android, board