2 and 4 Carburetor Synchronizer Tester Gauge Set for Cars and Motorcycles

2 and 4 Carburetor Synchronizer Tester Gauge Set for Cars and Motorcycles

Car and Motorcycle 2 and 4 Carburetor Synchronizer Gauge Set

Description:

- This gauge set professionally adjusts the carburetor negative pressure. 

- Ensures even and synchronous operation of compression, ignition and combustion. 

- Used to obtain the best engine performance and reduce fuel consumption. 

- Vacuum gauges allow correct adjustment through the corresponding adjustment screws on the carburetor. 

- Good throttle response achieves quiet engine operation, low vibration at all engine speeds, good acceleration, high speed, better combustion and lower fuel consumption. 

- For measurement synchronizes 2 to 4 carburetors, suitable for cars and motorcycles.

Specifications:

- This synchronizer is made of high quality material, higher corrosion resistance and better flow accuracy.

- Supplied with a set of long and short carburetor adapters and connectors for easy access and use.

- One of its functions is to help synchronize the values of up to 4 carburetors, as well as adjust and set them as the fuel pump carburetor test and transmission are automatically verified with 2-4 carburetors.

- A bank of 4 gauges with lockable valves allow vacuum values to be maintained in use.

- It is very easy to store and transport. Comes with a sturdy plastic case with handle and front locks for easy storage and transport.

- It is very easy to use. After connecting the dials to the carburetor, the negative pressure in the intake system can be measured. The low pressure dials allow correct alignment over the corresponding adjusting screws on the carburetor.

- It is energy saving. Well balanced throttle valves lead to optimum combustion. Lower fuel consumption, quiet engine operation, low vibration in all rpm ranges, good acceleration values and higher final speed help to save.

Includes:

- negative pressure hoses with all mounting hardware

- 4 pressure gauges mounted on metal plate

- 4 rubber hoses 8 x 5 x 750 mm

-  4 spare hose clamps and sealing rings

- 4 x 53 mm connectors (M6 x 0.75)

- 4 x 60 mm connectors (M6 x 1.00)

- 4 x 3.9 x 52 mm extensions

- 4 x 3.9 x 122 mm extensions

- Plastic carrying case

Note:

- No instructions included, professional installation recommended.

- Case color: case color may vary.