Usb Usc-32 Channel Servo Uart Controller Board Unit For Diy Robot For Arduino

Usb Usc-32 Channel Servo Uart Controller Board Unit For Diy Robot For Arduino

Up to 32 servo motors can be controlled at the same time, either by using a software on computer, or UART communication ( TTL serial port) of MCU (51, AVR, ARM, FPGA, PIC, etc.) to send command signals to control the motions. Besides, we can also download instructions to the servo motor controller for off-line operation.

Main Features:

Powerful MCU
High controlling accuracy
Offline operation function
Identify baud rate automatically
Details & Specs:

Controlling MCU power supply: 6.5~12 V or 3.5~5.5V. (USB can be used to power the chip on servos board. And it can be chosen automatically. With the USB reverse protection, it can protect your computer from been hurted by the reverse USB.)
Servos power supply: DC (depends on the motors, generally 5V DC)
Control channels: 32. (can be controlled at the same time and the accuracy can be adjusted)
Communication Input: USB or UART (TTL or USART). (The Bluetooth or some other wireless module can be used to make the controlling)
Signal Output: PWM (Accuracy 1us).
Servo motor resolution: 1us, 0.09 degrees.
Baud Rate: 9600,19200,28400,57600,115200,128000(recognized automatically)
Servo motors supported: Futaba, Hitec or some other Servos Motor controlled by PWM.
Board Size: 63.5mm * 43.5mm * 1.6mm.
Control mode: USB and UART (TTL) to accept command. (Comes with USB data wire and PC controlling software)
Flash memory: onboard 512K ROM (If every command is used to control the 32 motors at the same time, more than 500 commands can be saved.)